Gas Furnace Maintenance
Are you looking for gas furnace maintenance in Glen Ellyn, IL ? Our heating and furnace service technicians have years of experience working on furnaces like yours in Glen Ellyn, IL. Brian's Heating has service vehicles on call that are fully equipped with the tools and parts necessary to get your furnace back up and operating.
We offer gas furnace maintenance and maintenance agreements to keep your heating system running great. You can rely on Brian's Heating to advise you properly and to do excellent work promptly. Ask us about maintenance agreements for your high efficiency furnace today.
We provide gas furnace Maintenance Agreements in Glen Ellyn, IL
Urnace Report:
Boiler Report
• Inducer NA
• Clean Flame Sensor
• Inspect Blower Motor NA
• Inspect Wiring. No Issues
• Inspect Burner No Issues
• Inspect Orfices For Blockage NA
• Carbon Monoxide Test 0ppm Found
• Inspect Chimney No Issues
• Inspect Pressure Switch Lines NA
• Test Sequence Of Operation No Issues
• Inspect Heat Exchanger No Issues
• Check Ignitor Spark
• Check/replace Filter NA
• Test Gas Shut Off No Issues
• Test Thermostat For Proper Operation No Issues
Steven , C. Glen Ellyn, IL
02-01-2022
Humidifier Maintenance And Cleaning
Disassemble And Inspect Aprilaire Humidifier
-Clean Drain Assembly
-Clean Distribution Tray
-Clean Water Feed Tube
-Verify Water Flow, Clean Orifice
-Clean Or Replace Drain Tube As Needed
-Verify 24v Control Operation
-Replace Media Filter
Set Manual Controls @ 35% For Winter Opperaion.
Verify Automatic Control Set In
Upon Arrival Pre Clean Up Start Up Operations Good. Motors Are Working Well Within Amp Rate. Flame Sensor A Bit Dirty, Switches Are Good. Cleaned Up Flame Sensor, Motors Housing, Burner Assembly, Interior Of Furnace. Small Amount Of Rust Of The Interior Furnace, Current Filter Still Good. Offered Humidifier Maintenance & Customer Accepted. Furnace Manufactured 11/2004
Leslie, O. Glen Ellyn , IL
10-15-2021
Furnace Report:
Furnace Report
• Inducer Amps MNF/ - Test/0.4A
• Clean Flame Sensor Cleaned Flame Sensor
• Blower Motor Capacitor MNF/ - Test/N/A Relay ECM
• Inspect Wiring All Wiring Is Good
• Inspect Burner Cleaned And Cleared Burners
• Inspect Orifices For Blockage No Blockages
• Carbon Monoxide Test No Issues
• Inspect Chimney No Issues Chimney Is Venting Properly
• Inspect Pressure Switch Lines No Issues. Cleared Pressure Switch Lines
• Test Sequence Of Operation Sequence Of Operations Is Good And In Order
• Inspect Heat Exchanger No Issues . Clean Blue Flame
• Check Ignitor Ignitor Is All Good
• Check/replace The Filter Replaced Filter
• Test Gas Shut Off No Issues
• Test Thermostat For Proper Operation Thermostat Turns On Call No Issues
Steph, C. Glen Ellyn , IL
11-03-2022