Gas Furnace Maintenance

Furnace Report • Inducer Amps MNF/ - Test/2.0A • Clean Flame Sensor Cleaned Flame Sensor • Blower Motor Capacitor MNF/ - Test/ N/A Relay • Inspect Wiring All Wiring Is Good • Inspect Burner Cleaned And Cleared Burners • Inspect Orifices For Blockage No Blockages • Carbon Monoxide Test No Issues • Inspect Chimney Chimney/exhaust Is Venting Properly • Inspect Pressure Switch Lines Cleared Pressure Switch Lines • Test Sequence Of Operation Sequence Of Operations Is Good And In Order • Inspect Heat Exchanger No Issues. Clean Blue Flame No Cracks • Check Ignitor Ignitor Is All Good • Check/replace The Filter Recommend Replacing Filter • Test Gas Shut Off No Issues • Test Thermostat For Proper Operation Thermostat Turns On Call No Issues
Janet , B. Addison, IL
11-03-2022

Deep Coil Cleaning: Deep Cleaning Of Evaporator Coil Dissemble Coil Cabinet For Access To Evaporator Clean All Accessible Coil Fins And End Loops Coil/fin Brush All Aluminum/copper Coil Surfaces Clean Drain Pan Of All Debris Clear Condensate Lines Of Any Sludge + Does Not Include Cutting Of Refrigeration Piping For Access. An Additional Charge Will Be Added For Reclaiming, Evac, Startup. Annual A/C Preventative Maintenance: Clean And Check Outdoor Condenser High Pressure - 200 Low Pressure - 70 Ambient Temp - 79 Delta T Reading -20 Contactor Resistance Reading -18 Low Voltage Wiring Check Capacitor Reading 35/5 Clean Out Electrical Compartment Refrigeration Line Check - Low Side Insulation Service Valve Cap Amp Draw On Compressor -11.3 Amp Draw On Condenser Fan -1.26 Check Filter/Replace Clean Drain Test Blower Motor Service: Boiler Report • Draft Damper Operational • Verify Circulation Motor Operational • Inspect Wiring • Inspect Burner • Test Gas Valve • Inspect Orfices For Blockage • Carbon Monoxide Test • Inspect Chimney • Test Sequence Of Operation • Inspect Heat Exchanger • Test Spark Ignitor • Test Gas Shut Off • Test Thermostat For Proper Operation
Janet , B. Addison, IL
10-04-2021

Laurel , B. Addison , IL
02-06-2023

Annual Furnace Preventative Maintenance: Your Fall Preventative Maintenance Includes - Clean Burner Assembly - Clean Flame Sensor - Inspect Heat Exchanger - Check Igniter - Test Safety Circuit - Carbon Monoxide Test - Check Sequence Operations - Inspect Blower Motor And Cage - Measure For Correct Air Flow - Tighten Electrical Connections - Measure Volts/amps On Motors - Change Filter
Jeff , W. Addison , IL
11-05-2021

• Inducer MNF 3.7/Test 2.2 • Clean Flame Sensor • Inspect Blower Motor • Inspect Wiring • Inspect Burner • Inspect Orfices For Blockage • Carbon Monoxide Test • Inspect Chimney • Inspect Pressure Switch Lines • Test Sequence Of Operation • Inspect Heat Exchanger • Check Ignitor • Check/replace Filter • Test Gas Shut Off • Test Thermostat For Proper Operation • Clean 3/4 Drain Humidifier Maintenance And Cleaning Disassemble And Inspect Aprilaire Humidifier -Clean Drain Assembly -Clean Distribution Tray -Clean Water Feed Tube -Verify Water Flow, Clean Orifice -Clean Or Replace Drain Tube As Needed -Verify 24v Control Operation -Replace Media Filter Annual A/C Preventative Maintenance: Clean And Check Outdoor Condenser High Pressure - 200 Low Pressure - 70 Ambient Temp - 70 Delta T Reading -20 Contactor Resistance Reading - Low Voltage Wiring Check Capacitor Reading 44.9/5 Clean Out Electrical Compartment Refrigeration Line Check - Low Side Insulation Service Valve Cap Amp Draw On Compressor - 11.0 Amp Draw On Condenser Fan -1.2
Janet , B. Addison, IL
10-04-2021